SRS #3907

Tools/Options: Epiroc Diamondback DB40 Year: 2018: SOLD Drillers Console, Cyclone Hydraulic Tank, Primary Hydraulics, Rear Jack Module, Mud & Air Hosing, Lighting, Electrical Wiring for Standard Options, Tower Trunnion, Tower Raising Cylinders, FRP Decking for Base. Mud & Air Piping Valves Nordstrom and Operated Hydraulically from the Drillers Console. Compressor Module includes Oil Cooler, Hydraulic Oil Cooler and Oil Separator Tank. Electronic Air Regulation System for Control over Volume and Pressure. Namco Box includes Compressor Disconnect Function to fully Disengage Compressor. Standard 34' Derrick with 40,000# Pullback and 30,000# Pulldown with all Hoses, Carriage and Feed System. Newer 80,000# Tophead. 3" ID Head. 8,000 Ft-lbs@107 RPM 2-Speed Rotary Head and 5,362 Ft-lbs.@ 161 RPM. Top Bearing Lubricated with an Oil Pump. 0-184 Variable Control, 3" ID through the Head. 3.5" X 2-3/8" IF Crossover Sub and Accessories. 9-Piece X 3.5" Fixed Carousel with capability to remove or load rods from the side of carousel. 24" Table (T3W/TH-60 style) with Hydraulically Sliding Wrench which Slides from the Center Rear of the Table. The Rear of the Table Slides Hydraulically to give more room around the Table or to Clamp Casing in the Table. The Table has a 12.88" Bushing Insert that Bolts in the Outer Adapter. The Front of the Table is Pinned either Side to Allow for Pivoting to the Driller's or Helper's Side. The Table Front can also be Removed. 25 GPM Bean Water Injection with Foam, 18,000# 1-Part Main Winch, Braden Winch that Mounts to a Saddle on the back of the Tower. All Hoses and Electrical Connectors, Mounting bolt and Controllers are provided to plug into the option location. Winch can be Operated from the Driller and Helper side of the Rig. Sandreel Winch mounts to the back of the Tower and comes with all Hoses, Connections, Controls and Fittings to Mount to Option Location (not currently on the drill but included). The Winch can be Operated from the Driller and Helper Side of the Rig. Petol Breakout Wrench is bolted to the Helpers Side of the Tower, Wrench is Operated from the Drillers Console. Stand Alone Rod Box with Slide, Rod Spinner, Torque Limit Control, 7-Gallon Electric DHD Lubricator, Hydraulic Welder, Hub Odometer, Toolbox, Decking Located above DHD Lube Tank for Additional Storage Space. Truck has 22,000# Front Axles and 46,000# Rears, Differential Lock on both Rear Axles, Namco Transfer Case to Engage and Disengage Drilling Functions. Standard 247" Wheelbase, Fuller Transmission. Drill is set up to run 3.5" OD Pipe with 2-5/8" Threads. Pipe is Available for an Extra Cost. Rig is Capable of Carrying 480' of Pipe, 9 Rods in the Carousel and 15 in the Pipe Rack. Approx. 2,200 Current Compressor Hours and approx. 4,100 Rig Hours. Has a Sandline. Working Drill so Hours Increase. 2023 Engine had an In-frame Rebuild.