SRS #3818

Tools/Options: GEFCO 30K Year: 2006: SOLD 30,000# Pullback Capacity, Hydraulically Driven Mission Magnum Centrifugal Mud Pump, 20,000# Capacity Single Line Main Winch (2-part 40,000#), 6-Rod Carousel that is set up for 4.5" X 20' Drill Pipe, Single Rod Loader, Tophead Drive Cushion Sub, FMC 18 GPM Water Injection Pump, 7 Gallon Capacity DHD Lubricator, 4 Hydraulic Leveling Outriggers, Drill Pipe Spinner. 34,000 Miles Driven,. Odometer Reads 14,346 Hours, 138,466 Miles, Hub Meter Reads 34,212. No Pipe Included. Repair List to Date - CHASSIS: Replace broken cab clearance lights, replace two missing bumper bolts, straighten radiator grill, replace broken mirror above passenger door window, change engine & PTO oil & filters, replace bad sensor in CAT C15, install truck master clutch air cylinder, truck cab fuel level gauge not working. AIR COMPRESSOR SYSTEM; replace air compressor oil cooler & re-test for proper cooling, clean & adjust air compressor regulation system, replace 0-ring in minimum pressure valve, replace receiver tank pressure relief valve, check and make repairs on air compressor shut down system, replace oil & filters. DRILL: Install carousel, replace O-rings in leaking ball valves below hydraulic tank, replace derrick rest rubber pad so feed cables won't interfere with cab lights, replace tophead pulldown cables, replace missing screws in control panel, control panel gauges not working - oil pressure, tachometer & water temperature, secure control panel rotary drive pressure gauge, replace electric fan motor on hydraulic cooler, clean mud from main downhole air lines, pneumatic actuator for downhole air valve is missing bolts, replace broken carousel lower guide clamp, straighten single rod loader lower mounting plate & replace bolts, dead end of feed cables at derrick crown need to be shortened & clamps adjusted. SOLD