SRS #4014

Tools/Options: Speedstar SS-22: Capable of Range III Casing up to 44'. 10" GD Retractable Rotary Table, Rotary Transmission with 5 Forward & 1 Reverse, Bean 4-Cylinder Injection Pump, Custom Built 56' Heavy Duty 3" Square Tubing Mast with Huge Hydraulically Folding Racking Board & Heavy Duty Substructure. Drill is Set Up to Run 30' Drill Pipe, 36' X 6" Hex Kelly with Retract, 3" Little Giant Swivel Rebuilt, PTO Rebuilt. Front & Rear Air Actuators on Driller's Panel, Main Clutch Control below Driller's Panel, Completely Rebuilt SS-22 Double Drum Brake Drawworks with LeBus Grooving, 18" Air Clutches & 3rd Sandline Drum, Hydromatic Brake, 2 Huge Traveling Blocks, Newer Hydraulic Pump, (4) Hydraulic Jacks & (2) Screw Jacks under Rotary Table Frame, Planetary Pulldown, Hydraulic Spinning Chain, Folding Drill Floor, Newer LED Lights throughout Rig. Swivel REcently Machined to sit Tight in the Cradle and had the Kelly Pin Recut. Carrier has a Fuller Road Ranger Transmission. Engine has a new PCM & Injector Pump, Rear Air over Electronic 2-Point Throttle Control, All 12 Tires are Newer, Driven approx. < 500 Miles. Includes approx. 2,100' of 3.5" X 30' Drill Pipe with 3.5" IF Tool Joints & (6) Drill Collars, Slips, Screw Plug & Bit Subs. Un-used Weight Indicator with 2 Load Cells Available for an Extra Cost (not mounted on rig). Almost Everything has been Rebuilt on this Rig from Early to Mid 2000's to Present. Heavy Duty Rig with a Big Mud Pump and Small Footprint.