4492-4510/4506-1.jpg
4492-4510/4506-1tn.jpg
4492-4510/4506-2.jpg
4492-4510/4506-2tn.jpg
4492-4510/4506-3.jpg
4492-4510/4506-3tn.jpg
4492-4510/4506-4.jpg
4492-4510/4506-4tn.jpg
4492-4510/4506-5.jpg
4492-4510/4506-5tn.jpg

SRS #4506

Year: 1998
Make: Reichdrill
Model: T-690W
Compressor: 1050/350
Mud Pump: Plumbed - See Below
Engine: CAT 3406B
Mounted On: 1998 Mack
Truck Engine Make: Mack 350 HP
Tires: See Below
Condition: Working

Tools/Options: Reichdrill T-690W Year: 1998: REWORKED! Rapid Retract, 44,000# Pullback, 5" Cylinders, 140# Chains, 22" Table Opening, 6-Pod Carousel, Rebuilt Compressor (2017) approx. 1,350 Hours Since. Low Hours, Head Rebuilt in 2015, New Cooler (zero hours), New Separator Filter (10 hours), New Hercules Controls & Butterfly. 2020 New Motor for Water Injection, Deck Engine Rebuilt in 2019 approx. 1900 hours since, New Starter & Batteries, Deck Engine Battery Box Lid, Front & Left Rear Jack Pads New, Engine Heaters on both Engines. Replaced Ball Grip from A35 Control Handle, (4) Linkages on A20 Valve Bank Replaced, All Handles & Linkages on Triple Sub Plate Replaced, Water Injection 0n/off Control Replaced, Holdback Disengage Control Repaired, Holdback Pressure Gauge Replaced, Downhole Air Gauge Replaced, Rotation Gauge Replaced, Air Compressor Oil Injection Gauge Replaced, Tail Blowdown Cylinder Repacked, Tail Blowdown Cylinder Replaced, Hydraulic Tank Supercharge Gauge Replaced, Downhole Air Valve Hydraulic Cylinder Replaced, Deck Engine Hour Meter Replaced after Engine was Rebuilt. New 8 GPM Bean Water Pump, Guard over Chain Drive on Water Injection Pump, Knob on Fan Control Replaced, Barrel Loader Swing Cylinder Repacked, 3 Hydraulic Pump Replaced, Pump Gearbox Breather Replaced. Rear Clearance Light Bar on Truck Replaced. Fast Up-Pull Valve & Piston Pump Replaced. 2015 Bearing in Head was Replaced. Truck has approx. 58,000 Miles on it, an Eaton Fuller 8-speed Transmission + Low and Low/low, 3 Ranges in Reverse and 3 Ranges in Low. Jake Brake, 4.42 Rear-end Ratio. New Transmission and Clutch, New Drive Tires (8 total less than 300 miles), Steer Tires have about 3,000 Miles, New Windshield, Batteries, Driver side Seat and Power Steering Hoses have been replaced. Drill has had all Cylinders Rebuilt except for the Jacks, all Controls Rebuilt, Replaced 85% of all Hydraulic Hoses, Replaced Air Lines, Setup Filtered & Regulated Auxiliary Air off of Rig Compressor to run a Diaphragm Pump, Air Cylinder etc., Resealed Tophead. Rig can carry 260' in Rod Box and another 120' in Carousel. No Helper Controls, has a Catwalk and Platforms. Rig is Set Up to Run 4.5" Drill Pipe. 740’ of Near New 4 ½” x 20’ x 2 7/8” IF. Drill Rod Available for an Extra Cost.

Southern Office:
1485 DeSoto Blvd N
Naples FL 34120
Phone: 239.774.1939

Northern Office:
Oil City PA 16301
Phone Toll FREE: 1.888.204.3907