SRS #4377

Tools/Options: Atlas Copco T3W Deephole Year: 2006: SOLD 7,600 Original Hours. 55K Pullback, Heavy Duty Reinforced High Strength Steel Double Frame Full Length of Chassis. 4 Hydraulic Outrigger Stabilizer Jacks. Over Pressure Control System on Jacks. 4 Motor, High Torque - High Speed Tophead Drive, 35' Tower with 2 Retract Positions so Hammer can be Retracted while Installing Casing, 20" Hydraulic Open & close and Swinging Open & Close Access to the Centralizer Bushings. Air Operated Table Breakout Wrench and Air Operated Retract Access Gates. Hydraulic Powered Breakout Wrench, 7-Rod Carousel set up for 4.5" Diameter Drill Pipe Table Opening, 18" Bare Drum, Single Line Hydraulically Powered Main Winch. 2-Stage Oil Flooded Screw Compressor. 1800 RPM 565 HP High Duty Cycle Industrial C15 Engine. In-Out Box Disconnect Device between Engine & Compressor. 20 GPM Water Injection with Variable Speed Control, Jib Boom for Main Winch Line with Dual Controls, Swing and Extend Capabilities, Single Rod Load & Rod Storage Box, Under Deck High Capacity Fuel Tank for Deck Engine, Under Deck Tool Box. 500' Rod Storage (25 pieces of 4.5" X 20' Cyclone Style Flush Joint Pipe) Truck Odometer Reads 3,248 Miles and 3,533 Engine Hours. Will Include some Used Drill Pipe and a Used 6" & 8" Hammer. Tophead was Replaced with a Rebuilt one by Previous Owner. SOLD